Skip to content
KaajVa

RO Water Purifier Service: When to Change Filters and Membrane

Your RO purifier only gives safe, good-tasting water if its filters are changed on time. This guide explains what each filter does, how often to replace them, the signs that your purifier needs a service, and what to expect to pay.

By the KaajVa team 4 min read

How an RO purifier works

Most home purifiers combine several stages. A sediment filter removes sand and rust. Carbon filters remove chlorine, odour and some chemicals. The RO membrane removes dissolved salts and many contaminants. Many purifiers add UV or UF stages to kill or remove bacteria, and a post-carbon or mineral cartridge to improve taste.

Each stage protects the next. A clogged sediment filter makes the membrane work harder and wear out sooner, which is why regular service saves money.

How often to change each part

These are general guidelines. Hard water, borewell water or heavy use means more frequent changes; your technician can test TDS and advise.

  • Sediment filter: every 3 to 6 months.
  • Pre and post carbon filters: every 6 to 12 months.
  • RO membrane: every 1 to 2 years, depending on water quality.
  • UV lamp: about once a year, as its output weakens even if it still glows.
  • General service and sanitisation of the storage tank: every 3 to 6 months.

Signs your RO needs a service

Call a technician if you notice any of these.

  • Water flow has slowed or the tank takes much longer to fill.
  • Water tastes or smells different, or looks cloudy.
  • The purifier makes unusual noises or runs constantly.
  • Water leaks around the unit.
  • The filter change indicator is on.

Typical RO service charges

A basic service visit is usually a few hundred rupees. Filter kits and membranes are charged separately and vary by brand; a membrane is the most expensive consumable. Annual maintenance contracts that include filters are common and often worth it if you use the purifier daily.

Ask whether the filters are original or compatible, and ask the technician to show you the old filters. A properly used sediment filter will be visibly discoloured.

Do you even need RO?

RO is best for water with high dissolved salts (high TDS), such as some borewell supplies. If your supply is municipal water with low TDS, a UV or UF purifier may be enough and wastes less water. A technician can test your water TDS in a minute and advise honestly.

RO purifiers reject some water during purification. You can collect it for mopping, washing vehicles or watering plants.

What happens during an RO service

A proper service is more than swapping a filter. Expect the technician to check input water pressure and TDS, inspect and clean or replace pre-filters, check the membrane output, test the pump and the auto-cut switch, look for leaks at every joint, and clean and sanitise the storage tank. They should then check the TDS of the purified water and show you the reading.

Ask for the old filters to be shown to you, and for a service card that records the date and what was replaced. It makes the next service easier and protects you from paying for parts that were not changed.

Choosing between brand service and local technicians

Brand service is convenient while your purifier is under warranty and uses original parts, but it usually costs more. Independent technicians often service all brands and can be much cheaper, especially for older purifiers. The key is the quality of the filters: ask whether they are original or compatible, and whether they carry any warranty.

  • Under warranty: use the brand's authorised service.
  • Out of warranty: compare a local technician's price for the same filters.
  • Annual contract: check how many visits and which parts are included.

Water quality in Siliguri and North Bengal

Water sources vary widely across Siliguri, from municipal supply to borewells and tanker water. Borewell and tanker water can have higher iron, sediment and TDS, which clogs filters faster. If your filters seem to choke quickly or you see brown stains in the storage tank, ask the technician about an extra pre-filter or iron removal cartridge before the RO.

After heavy monsoon rains, when supply water can be muddier, it is worth checking and changing the sediment filter earlier than usual.

Keeping your purifier healthy between services

Use the purifier regularly; water standing in the tank for many days encourages bacteria. If you are away for more than a week, drain the tank on your return and let the purifier refill it. Keep the unit away from direct sunlight, and wipe the outside and the tap regularly.

Frequently asked questions

How often should an RO purifier be serviced?

Every three to six months for a general service, with filters and membrane replaced on their own schedules depending on water quality.

What is a good TDS level for drinking water?

Many experts consider roughly 50 to 300 mg/L pleasant and acceptable. Very low TDS can taste flat; very high TDS tastes salty.

Can I change RO filters myself?

Some purifiers use easy twist-off cartridges, but most need a technician to open the unit, change filters and check for leaks.

Why is my RO water tasting salty?

Usually a worn-out membrane or a problem with the TDS controller. Get the membrane checked.

Prices in this guide are typical ranges for guidance only. They vary by city, provider and the exact job; always ask for a quote before work starts.

More guides